Resetting errors on an Indesit washing machine

You can reset an error on your Indesit washing machine if it was caused by a temporary system failure. If the error code persists, it indicates a specific problem that shouldn't be ignored. Let's look at what to do in each situation.

Removing the code

Many users try to reset the error by simply disconnecting the power from the Indesit washing machine. However, often unplugging the power cord doesn't help—the error code reappears after being turned on. Here's what to do:

• turn on the SMA;
• press and hold the “Start/Pause” button for 4-6 seconds;
• wait until the indicators on the dashboard turn green and go out;
• Make sure the error is cleared.

On older Indesit machines, it may be necessary to additionally set the program selector to the neutral position. Once the error has been successfully reset, the control panel will be unlocked and the washing machine can be used.

If the method described above does not help to reset the errors, you can try this method:

• turn the programmer to the first position;
• press and hold the “Start/Pause” button for 4-6 seconds;
• Disconnect the machine from the power supply by pulling the power cord out of the socket;
• Connect the washing machine to the power supply and run a test cycle.

This way you can reset an error that appeared as a result of a short-term software failure.

If the error code remains even after these steps, there's a real problem. The washing machine will need to be diagnosed and repaired. We'll explain what errors Indesit owners might encounter.

What errors does the user encounter?

Modern Indesit washing machines are equipped with a sophisticated self-diagnostic system. They easily detect malfunctions and notify users. The decoding of error codes is provided in the equipment instructions. We'll tell you what problems certain errors indicate.

• F01 indicates damage to the electric motor.
• F02 indicates that the motor is not functioning properly.
• F03 indicates that the temperature sensor is faulty.
• F04 informs about a malfunction of the water level sensor.
• F05 indicates a failure of the drain pump.
• F06 indicates a button error.
• F07 signals that the pressure switch has stopped working after water has been drawn in.
• F08 indicates a heating element failure.
• F09 reports a control module memory error.
• F10 informs that water is being collected in the tank too slowly.
• F11 signals a fault in the drain pump circuit.
• F12 indicates that there is no communication between the instrument panel indicators and the control module.
• F13 notifies about the failure of the drying temperature sensor.
• F14 indicates that the heating element of the drying chamber has failed.
• F15 signals damage to the drying heating element relay.
• F16 signals that the washing machine drum is blocked (typical only for vertical machines).
• F17 informs about the failure of the UBL.
• F18 warns of problems in the control board processor.
• H20 indicates problems with filling the tank with water.

The list of errors programmed into the memory of Indesit washing machines is quite extensive. By deciphering the error code, you can begin troubleshooting the problem without wasting time and effort on a general diagnosis.

   

Readers' comments